WARNING

Meals Poisoning Hazard

Do not let meals sit in oven more than one hour before or after cooking.

Doing so may end up in food poisoning or sickness.Vital: Food should be at serving temperature earlier than placing it within the warmed oven. Meals could also be held up to 1 hour; nonetheless, breads and casseroles might develop into too dry if left in the oven through the Keep Warm perform. For best outcomes, cover food. The Keep Warm feature allows sizzling cooked foods to remain at serving temperature.To use:1. Press KEEP Warm.2. Press the number keypads to set the desired temperature. If the temperature entered is not within the vary of the temperatures allowed, the minimal or most allowed temperature will likely be displayed. Enter a temperature within the allowable vary.

Be aware: The temperature could also be changed at any time by pressing the quantity keypads to enter the specified temperature after which Start/ .3. Press Start/ .4. Place food within the oven.5. Press OFF/CANCEL/6. when finished.7. Remove meals from the oven.

To Cancel Keep Warm:1. Press OFF/CANCEL/2. Take away meals from oven.

Favourite

On demand for some furnaces from Koyo Thermo Methods it is feasible to inte-grate a Stange controller as an alternative of a regular controller to make use of the benefits of Stange controller. This system controller mannequin varies with the system complexity. Utilizing native peripherals the system may be enlarged on demand with additional modules per digital and analog outputs and in addition belatedly connected to an ECS-2000.

Other problems could cause the electronic control board to fail. Regular put on and tear eventually takes it toll on a circuit board and causes its failure. A short Cooker hood circuit board in a part resembling a heating ingredient, fan, control panel or sensor can injury the electronic management board. A service tech can often determine the cause of a control board failure and change additional components if needed to forestall the control board from going out shortly after changing it.

Instead of this system controller SE-502 the SE-504 affords 30 actual values and 64 digital tracks. 20 management zones with 8 parameter units, tolerances and a couple of thresholds per zone improve the functionality of this controller monumental. Additionally the system is able to enter forty eight precise values (norm signals, thermocouples, PT100) and the included S5-appropriate PLC can operate 20.000 instructions from CPU-928 instruction set. 40 formulation can be found. The method is secured with 200 alarms (precedence, delay and alarm message configurable). Another special operate which isn’t out there with SE-502 is nitriding coefficient. Its dimensions are very compact 288 x 144 x 105mm and it additionally contains an illuminated LC-show with a resolution of 160 x 128 pixel.

This Stange Elektronik program controller supports the method configuration saving both on Computer and Memory-Card. For different configuration characteristic please refer back to SE-502.

The difference between SE-502 and SE-504 regarding programming is the larger quantity of fifty applications and 50 segments.

Below operations the number of operator panels enlarges from 6 to 8.

The Stange Elektronik program controller SE-504 presents a bigger range of control prospects and is a compact and easily configurable management machine for advanced processes.

That’s all there may be to this one; the sensor was set for 66C, and the controller was ready to hold temperature effectively enough to maintain the LO within one hundred fifty Hz when subjected to the muffin fan 10-minute stress take a look at. You can probably get even higher stability through the use of some insulation across the LO, but even with out it, the stability is significantly better.